Assigning An Output To Auxiliary (Aux) - Datavideo SE-1000 Instruction Manual

To cancel the key effect push the T-Bar the other way, or press the AUTO Button, the output will switch back
to the live source without key.
Assigning a signal to the Auxiliary Output
The Auxiliary Output (AUX) can be assigned with any one of the seven crosspoints, the Preview (PVW),
Program (PGM) or Clean (CLN) output. The Clean (CLN) output is the same as the Program (PGM) output
but with any KEY images removed.
To assign an output to Auxiliary:
Press and hold the AUX button so that it is illuminated.
While holding the AUX button in, press the button of the source that you want to assign, so that it is also
illuminated, in the example above crosspoint 6 is assigned.
To assign a crosspoint, press and hold the AUX button and press the crosspoint button 1 to 7 on the PST/B
rail, then release the AUX button.
To assign the Program (PGM), Preview (PVW) or Clean (CLN) outputs, press and hold the AUX button and
press the [PGM], [PVW] or [CLN] buttons, then release the AUX button.
50