Print Current Settings; Change Settings; Set Memory Switches - Infinite Peripherals DPP-255 User Manual

DPP-255 User Manual

Print Current Settings

The function set mode switches register functions in memory
manually.
1. Once the printer is turned on, release the Power button
when Hardware Setup begins printing.
2. To print the memory switch data, press the Feed button.

Change Settings

In the Function Setting mode, press the Feed button to
select a setting. Press the Power button to move to the next
setting.
1. In Function Setting mode, press the Feed button at the
Enter Setup prompt.
2. Change the settings, as needed:
• Restore factory default
• Change Memory Switch
* Enable Sound
* Execute <CR> As <LF>
• Change Baud Rate
• Change Auto Off Time
• Change Print Darkness
• Change Character Table
• Change Pairing Info
• Change USB Device Class
3. At the Store Setting prompt, press Feed to store the
settings.

Set Memory Switches

If needed, you can reset the memory switches to the factory
defaults.
Note
The memory switch is selected by values; 0=No or 1=Yes.
1. Change Memory Switches
• Enable Sound — Buzzer on or off.
• Execute <CR> As <LF> — Disable CR or Enable CR.
• Disable <LF> After <CR> — Enable LP after CR (only the
switch NO3=0) or Disable LP after CR.
• Default Small Font — 0=Font A (24x12) or 1=Font B
(16x9).
• Use Gap Sensor — 0=BM sensor or 1=GAP sensor.
• Black Mark Mode — Disable black mark detection or
Enable black mark detection.
• Disable Discoverable — Bluetooth discovery mode or Not
Bluetooth discovery mode.
• Enable USB Interface —Disable USB function or Enable
USB function.
• USB in Device Mode — USB not used device or USB used
in device.
2. Change Baud Rate — Select one:
• 1200 bps
• 2400 bps
• 4800 bps
• 9600 bps
• 19200 bps
• 38400 bps
• 57600 bps
• 115200 bps
18