Using Your Dpp-255; Attach Belt Clip; Paper Feeding; Backlash - Infinite Peripherals DPP-255 User Manual

DPP-255 User Manual

Using Your DPP-255

Attach Belt Clip

1. Using your fingers, insert the two screws provides
through the holes on the belt clip.
2. Tighten the screws with an appropriate screwdriver.

Paper Feeding

Two paper feeding concepts are important to understand.

Backlash

Backlash in the paper feed mechanism and may lead to
under feeding and crowding of characters on the adjacent
lines.
Note
When beginning initialization, printing, and after opening
and closing the thermal head, ensure to turn the paper feed
motor 24 steps (3 mm).

Graphics

If there is a lag time when the printer receives data from a
host computer during printing, the printer stops printing and
feeding paper temporarily. Once new data is received and
printing is resumed, the paper feeding for 1 to 3 lines can
become irregular, especially if the graphics are 8- or 16-bits
images.

Setting Peeler for Labels

1. Open the cover and insert the labels into the printer
with the end of the roll showing 1.5 inches (40 mm)
approximately.
2. Close the cover.
3. Raise the peeler arm, and then pull the label-end toward
the back of the printer.
4. Lower the peeler to secure the label in place.
5. Press the Feed button on the front of the printer to set
the position of the label.
13