DPP-255 User Manual
Installing a Paper Roll
You can drop and load a new paper roll into the printer
easily. Ensure the paper head is cool before placing the
paper roll into the printer.
1.
Press the Paper Cover Release button.
2.
Pull the paper guides apart gently.
3.
Insert a paper roll with the end of the roll facing
backwards and under the compartment.
4.
Pull the end of the roll outside of the paper feed area.
5.
Close the cover.
Print Labels
Depending on the paper width, paper position, and tolerance,
the left and right margin calculated space may shift
approximately +/- 1mm on the right and left sides.
(Optional) The Gap Sensor (transparent photo interrupter)
and Black Mark Sensor (reflective photo interrupter) are at
the top of the form.
Set-up Label Printing
1.
Set the paper sensor to marking detector using the FF
command.
2.
Ensure the marking height is 3mm to 6mm.
Note
If over 6mm, the marking is not detected within 360 and
detects it as the end of the paper.
3.
Once marking is selected, press the Feed button to feed
the paper to the next marking position.
4.
To adjust the sensitivity of the sensor, type the ESC CSL
command.
Note
Be aware of the printing position variances, +/-2mm
at the top/bottom and +/- 1mm on the left and right
margins.
5.
Set the end of the paper with at least 10mm excess from
the cutter.
14
Need help?
Do you have a question about the DPP-255 and is the answer not in the manual?
Questions and answers