Miele KFN 37432 iD Operating And Installation Instructions page 92

Installation
 Carefully remove the protective foil
from sealing strip .
 Fix sealing strip  flush with the front
of the appliance on the door opening
side.
1. Position the sealing strip flush with
the lower edge of the top fixing.
2. Stick it down along its entire length.
Installing the appliance
If the appliance is pushed too far into
the niche, the doors may not close
properly once the furniture doors
have been fitted. This can cause ice
to build up, condensate to
accumulate and lead to faults in the
appliance. These can all lead to
increased energy consumption.
Push the appliance into the building-
in niche making sure a gap of 42 mm
is maintained all round between the
appliance carcase and the front of
the housing unit side walls.
92
 Push the appliance into the niche
until all fixing brackets at the top and
bottom are in line with the front edge
of the housing unit side wall.
This will create a gap all round of
42 mm to the front edges of the
housing unit side walls.
–  With 16 mm thick walls:
The spacers should touch the front
edge of the housing unit side walls at
the top and bottom.
–  With 19 mm thick walls:
The front edges of the top and
bottom hinges should be flush with
the front edge of the housing side
wall.