Installation; Side-By-Side; Location - Miele KFN 37432 iD Operating And Installation Instructions

Installation

Installation

Side-by-side

The KFNS 37432 iD freezer has two
foamed in side-wall heaters enabling
them to be installed side-by-side with
other appliances. Each appliance must
be installed in its own niche.
Your dealer will be able to advise you
on which combination of models is
possible.

Location


Danger of damage and injury
due to the refrigeration appliance
tipping over.
This refrigeration appliance must be
built in, otherwise it could tip over.
Keep the appliance door(s) shut until
the refrigeration appliance has been
built in and secured in its housing in
accordance with these operating and
installation instructions.

Fire risk and risk of damage from
appliances which give off heat.
Appliances which give off heat can
catch fire and set fire to the
refrigeration appliance.
This refrigeration appliance must not
be installed underneath a hob.
This appliance should be installed in a
dry, well-ventilated room.
When deciding where to install your
refrigeration appliance, please bear in
mind that it will use more energy if
installed near to a heater, a cooker or
other appliance that gives off heat.
Direct sunlight should also be avoided.
76
The higher the room temperature, the
longer the compressor runs and the
higher the energy consumption is.
When installing the refrigeration
appliance, please note:
– The socket must be easily accessible
in an emergency, not concealed
behind the appliance.
– The plug and power cable must not
touch the rear of the refrigeration
appliance as they could be damaged
by vibrations from the appliance.
– Do not plug in other appliances
behind this refrigeration appliance.