You can disable the holster sensor temporarily or permanently. This feature allows you to prevent one
or all events from being reported OTA.
This feature is enabled through Customer Programming Software (CPS) configuration. Check with your
dealer or system administrator for more information on the programming of this feature.
2.22.16.1
Holster Sensor
Holster sensor monitors the state of the holster and allows the radio to send an over-the-air (OTA)
notification whenever a gun or a taser is pulled out of the holster or put in the holster.
NOTICE: Applicable for APX 7000 only.
2.22.16.2
Disabling the Sensor
This feature gives you an option to avoid sending the sensor events to the system by disabling the
sensors temporarily or permanently.
NOTICE: The feature is only applicable to holster sensor and weapon fired sensor. Vest
pierced sensor cannot be disabled.
2.22.16.2.1
Disabling the Sensor Temporarily
Procedure:
1 Short-press the preprogrammed Sensor button or the preprogrammed Menu Select button to
activate the sensor timer.
The following scenarios affect the sensor state:
•
If a gun or taser is removed from the holster within the timer duration, the timer stops and
switches the sensor to disabled state. A tone sounds and the radio displays Sensor
Disable.
NOTICE: The radio enables the sensor only when all the guns or tasers are placed
into the holster. A tone sounds and the radio displays Sensor On temporarily.
•
If the timer expires without an event, a tone sounds, the radio switches the sensor to enabled
state, and clears the sensor status from the display.
•
If the preprogrammed Sensor button or the preprogrammed Menu Select button is long-
pressed, the over-the-air (OTA) sensor notification is enabled.
2.22.16.2.2
Disabling the Sensor Permanently
Procedure:
1 Long-press the preprogrammed Sensor button or the preprogrammed Menu Select button to
permanently disable the sensors.
6875945M01-NL
Advanced Features
139