Holster Sensor; Weapon Fired Sensor; Vest Pierced Sensor; Disabling The Sensor - Motorola APX 8000HXE 1.5 User Manual

Table of Contents

Advertisement

NOTICE: The radio reports the next event after the preprogrammed 15-second timer expires.
Any consecutive event occurring within the timer is not reported to avoid multiple reports over
the same incident.
6.14.10.1

Holster Sensor

Holster sensor monitors the state of the holster and allows the radio to send an over-the-air (OTA)
notification whenever a gun or a taser is pulled out of the holster or put in the holster.
The sensor can cache events that happen when the sensor is disconnected from the radio. When the
sensor is reconnected, the radio evaluates and sends the important events OTA to the system. Check
with your system administrator for more information about these cached events.
If the sensor is disconnected from the radio for more than 30 minutes or it is disabled, the holster
sensor clears the cached events.
6.14.10.2

Weapon Fired Sensor

The feature allows the radio to send an over-the-air (OTA) notification when a weapon enabled with the
sensor is fired. The event is immediately sent to the system to alert the dispatcher of the weapon fired
incident.
6.14.10.3

Vest Pierced Sensor

Vest Pierced sensor is located inside a bulletproof vest. The sensor reports an event to the radio when
the vest is pierced due to various causes such as bullet shot or knife stabbing.
The feature allows the radio to send an emergency message and over-the-air (OTA) notification when
a vest piercing event occurs. The event is immediately sent to the system to alert the dispatcher of the
vest pierced incident.
The receiving radio displays VPierced RCVD to indicate that the sender is in a Vest Pierced
Emergency event.
6.14.10.4

Disabling the Sensor

This feature disables the sensors temporarily or permanently from sending the sensor events to the
system.
NOTICE: The feature is only applicable to holster sensor and weapon fired sensor. Vest
pierced sensor cannot be disabled.
6.14.10.4.1
Disabling the Sensor Temporarily
Procedure:
1 Short-press the preprogrammed Sensor button to activate the sensor timer.
The following scenarios affect the sensor state:
If a gun or taser is removed from the holster within the timer duration, the timer stops and
switches the sensor to disabled state. A tone sounds and the radio displays Sensor
Disable.
MN006727A01-AA
Advanced Features
67

Advertisement

Table of Contents
loading

Table of Contents