Installation - ADJ ENCORE BURST UV IP User Instructions

Encore Burst UV IP
Always ensure that the unit is firmly fixed to avoid vibration and slipping while operating. Always
ensure that the structure to which you are attaching the unit is secure and is able to support a weight
of 10 times the unit's weight. ALWAYS use safety cables that can hold 12 times the weight of the
unit when installing the fixture. This equipment must be installed by a professional, and it must be
installed in a place where it is out of the reach of people's grasp.
The Encore Burst UV IP is fully operational in three different mounting positions; hanging upside-down,
mounted sideways on trussing, or set on a flat level surface. Be sure this fixture is kept at least 12m
(40ft) away from any flammable materials (decoration etc.).
OVERHEAD RIGGING: The Encore Burst UV IP includes two rigging options.
1) OMEGA BRACKET - Mount the fixture with an appropriately reated professional grade rigging
clamp (not included) to the included Omega Bracket using an M12 screw and nut (not included).
With the rigging clamp securely attached to the Omega Bracket, attach the Omega Bracket to the
fixture by inserting both of the 1/4-turn quick-lock fasteners into the aligning holes on the fixture
yoke bracket, and turning each clockwise to secure.
MAKE SURE THE OMEGA BRACKET IS SECURELY ATTACHED BEFORE RIGGING FIXTURE!
2) MOUNTING YOKE - Mount the fixture with an appropriately rated professional grade rigging clamp
(not included) to the fixture yoke bracket center hole using an M12 screw and nut (not included).
MAKE SURE THE CLAMP IS SECURELY ATTACHED BEFORE RIGGING FIXTURE!
SAFETY CABLE: Pull the safety-cable through the opening located on the rear of the unit and over
the trussing system or a safe fixation spot. Insert the end in the carabine and tighten the safety
screw. ALWAYS use and install a safety cable as a safety measure to prevent accidental damage
and/or injury in the event the clamp fails.
ADJ Products, LLC - www.adj.com - Encore Burst UV IP User Manual Page 9
CLAMP
5.35" / 136mm
OMEGA BRACKET
CLAMP
SAFETY CABLE
RIGGING POINT

Installation

SAFETY CABLE
(Not Included)