ADJ ENCORE BURST UV IP User Instructions page 18

Encore Burst UV IP
SET ADDRESS - In this menu you can find and set your desired DMX address.
DMX CHANNEL MODE - In this menu you can find and set your desired DMX channel mode.
NO DMX STATUS - This menu setting is used as a precaution mode in case the DMX signal is lost
or interrupted. The operating mode chosen in this menu is the running mode the fixture will go into
when the DMX signal is lost. Listed below are the 3 modes.
• Hold Last - This setting will have the fixture stay in the last DMX setup.
• Blackout - This setting will have the fixture automatically go into stand by mode.
• Manual - This setting will go into the current manual control set up. See MANUAL CONTROL.
DIM MODES - In this menu you are able to select your desired dimmer mode and adjust the dimming
speed time.
LED REFRESH RATE - In this menu you are able to select your desired LED refresh rate.
GAMMA - In this menu you are able to select your desired gamma setting.
DISPLAY - In this menu you you are able to activate/deactivate the display blackout and activate/deactivate
the display lock.
SERVICE - In this menu you are able to access and adjust/change: the calibration (effect adjust) and
restore the factory settings.
MANUAL CONTROL - This menu is for manual testing and manual control. The dimmer and strobe
can be tested/adjusted. The fixture must be set to "Manual" under "No DMX State".
FIXTURE LIFE TIME
• Power On Time -The TOTAL power ON running time of the unit is displayed. This time CANNOT
be reset.
• P-On Time-R - The CURRENT power ON running time of the unit is displayed. This running time
may not be the same as the TOTAL power ON running time displayed under "Power On Time".
This time CAN be reset. NOTE: The displayed time represents the current power ON time
since the last reset.
• P-On Time-Reset - Reset the CURRENT power ON running time that is displayed under "P-On Time-R".
ADJ Products, LLC - www.adj.com - Encore Burst UV IP User Manual Page 17
System Menu