Inset Wall Mounting - Evonic Fires Topaz Instruction Manual

To wall mount this appliance, please follow the subsequent instructions.
Please refer to technical specification page for exact measurements,
ensuring the space you wish to install the appliance fits correctly.
This product has been designed to be
installed into a plaster board, drywalled, or
existing masonry chimney breast.
Please seek advice from a professional, with
reference to the structural integrity of the
installation site.
PLEASE NOTE: The screws and wall plugs
provided are only suitable for a solid wall
fixing / when installing onto a hollow-stud
wall it is recommended that heavy duty
wall anchors or equivalent are used.
The product should never be sealed into a
opening with the use of silicones or adhe-
sives as this can also alter the airflow and
hinder any further servicing of the product.
To begin the wall-mounting procedure,
measure the width, depth and height
of your appliance along with the space
you wish to install the fire into. Fig 1.
Fit your fire into the cavity, ensuring it is
adequately supported. Then secure the
spacer by screwing the fixing points into
the fireplace (fig 2)and attach the frame
using magnets in each corner (fig 3)

Inset Wall Mounting

w
H
Fig 1.
Fig 2.
Fig 3.
D
12.