Particular requirements for room heaters Particular requirements for room heaters UKCA STANDARDS All Evonic Fires products are in conformity with the relevant UK Statutory Instruments All Evonic Fires products are in conformity with the relevant UK Statutory Instruments (and their amendments).
IMPORTANT INFORMATION AND HEALTH & SAFETY When using electrical appliances, basic precautions should always be followed to reduce the risk of fire, electric shock, and injury to persons, including the following: • Read all of the instructions carefully before using the appliance, only use this appliance as described in this manual.
MODEL DIMENSIONS The model shown in these drawings is a Gilmour 7, however the same processes apply to all Suites. Scan the QR code for more detailed specification drawings. SUITES & STOVES MANUAL ISS. 14 SUITES & STOVES MANUAL ISS. 14 EVONIC - 104 INSTRUCTION GUIDE TEMPLATE ISSUE 1 EVONIC - 104 INSTRUCTION GUIDE TEMPLATE ISSUE 1...
Page 8
MODEL DIMENSIONS Model Width Height Depth Overall unit Overall unit With Riser / Opening Overall unit Bench (C) Aaren 845mm 687mm 457mm 360mm Banff 460mm 670mm 310mm 355mm Bergen 1475mm 615mm 355mm 357mm Bonham 7 1120mm 2027mm 2285mm 285mm 276mm...
Page 10
INSTALLATION INSTALLATION REQUIREMENTS Before installing the appliance please read and take into account the following important requirements; • The appliance must never be installed in front of an electrical socket. • The appliance must not be installed anywhere that it may come into contact with water, i.e.
Page 12
Determine the finished height and position that you want the appliance to be located. Then secure the wall bracket to the wall in the position you need using the wall plugs and screws provided. If you’re not securing the appliance to a masonry wall you will need to use the appropriate fixings.
Page 14
INSTALLATION INSTALLATION REQUIREMENTS Before positioning the appliance please read and take into account the following important requirements; • The appliance must not be located anywhere that it may come into contact with water, i.e. a bathroom. • This appliance is only suitable for indoor use, do not use outdoors. •...
FRONT AND SIDE GLASS FRONT AND SIDE GLASS INSTALLATION INSTALLATION Pivot Install Slotted Install Slide Install Aaren Aaren Banff Banff Halden Halden Bergen Bergen EV8S EV8S Kalmar Kalmar Halmstad Halmstad Kibo Kibo Tuva Tuva Midori Midori Nessa Nessa EVONIC - 104 INSTRUCTION GUIDE TEMPLATE ISSUE 1 EVONIC - 104 INSTRUCTION GUIDE TEMPLATE ISSUE 1 SUITES &...
Page 19
PIVOT INSTALL The pivot install of the front glass applies to the Aaren, Bergen, Kalmar, Kibo, Midori, and Nessa. The model shown in this example is an E1030, but the same process applies to all six models. Unscrew and remove the top and bottom glass retainer panels.
Page 20
Apply the Suction Lifter to the glass and apply the glass to the bottom edge first, then pivot into the appliance. Warning The Suction Lifter is provided to assist in moving the glass NEVER as the sole support of the glass. Always support the glass throughout the entire process until the glass is fully fitted.
Page 21
SLOTTED INSTALL The slotted install of the front glass applies to the Banff, EV8S, Halmstad, and Tuva. The model shown in this example is the Halmstad, but the same process applies to all four models. To install the front glass first locate the four keyhole slots on the front of the appliance, and the four screws on the back of the front glass.
Page 22
SLIDE INSTALL The sliding install of the front glass applies only to the Halden model. To remove the glass from the Halden model, first slide the lid back slightly, then lift. Warning Always support the glass throughout the entire process until the glass is fully fitted.
Page 24
Evoflame Only - LED Strip Replacement Scan the QR code to be taken to a video in our maintenance series. Please note; this video shows an old method of removing the front glass panel. Refer to page 19 of this instruction manual for the new method.
Page 25
REPORT A FAULT If you have any difficulties or problems with your appliance then please get in touch so that we can assist you. Please scan the QR code to be taken to our websites Report a Fault page, we will then be in touch with you shortly. SUITES &...
Page 26
WARRANTY If this appliance should prove to be defective due to faulty design, materials or workmanship within 12 months of purchase, the product will be repaired free of charge, subject to the following conditions: The electric fire shall have been purchased and used solely within the UK and Ireland for domestic purposes and in accordance with the Users operating instructions.
Need help?
Do you have a question about the Aaren and is the answer not in the manual?
Questions and answers