AEG DUK731110M User Manual page 13

7.2 Setting and changing the
time
After the first connection to the mains,
wait until the display shows
"12" flashes.
1. Press or
2. Press .
3. Press or
4. Press .
The display shows the new time.
To change the time of day press
again and again until
7.3 Setting the DURATION
1. Set a heating function and
temperature.
2. Press again and again until
starts to flash.
3. Press
or
DURATION.
4. Press or the DURATION starts
automatically after 5 seconds.
5. Press or
DURATION.
6. Press or the DURATION starts
automatically after 5 seconds.
When the set time ends, the signal
sounds for 2 minutes. The display shows
flashing and time setting. The oven
turns off.
7. Press a sensor field to stop the
signal.
8. Turn off the oven.
7.4 Setting the END
1. Set a heating function and
temperature.
2. Press again and again until
starts to flash.
3. Press
or
press . First you set the minutes
and then the hours.
When the set time ends, the signal
sounds for 2 minutes. The display shows
flashing and the time setting . The
oven turns off automatically.
and 12:00.
to set the hours.
to set the minutes.
starts to flash.
to set the minutes for
to set the hours for
to set the END and
4. Press a sensor field to stop the
signal.
5. Turn off the oven.
7.5 Setting the TIME DELAY
function
1. Set a heating function and
temperature.
2. Press
again and again until
starts to flash.
3. Press or
DURATION.
4. Press .
5. Press or
DURATION.
6. Press .
The display shows flashing
7. Press or
and press . First you set the
minutes and then the hours.
The oven turns on automatically later on,
works for the set DURATION time and
stops at the set END time. When the set
time ends, the signal sounds for 2
minutes. The display shows flashing
and the time setting . The oven turns off
automatically.
8. Press a sensor field to stop the
signal.
9. Turn off the oven.
When the Time delay
function is turned on, the
display shows a symbol of
the heating function,
a dot and
which clock function is on in
the Clock / residual heat
display.
7.6 Setting the SET+GO
You can use the SET+GO function only
when the DURATION is set.
1. Set a heating function and
temperature.
2. Set the DURATION.
3. Press again and again until the
display shows flashing
ENGLISH 13
to set the minutes for
to set the hours for
.
to set the END time
with
. The dot shows
.