Maintenance - Swann AMU Rescon Operator's Manual

AMU Rescon
Program List and Explanations
2.2.2
2.2.2.1
2.3 Sample
2.3.1
2.4 I/O State
2.4.1
2.5 Interface

3 Maintenance

3.1 Simulation
48
Miscellaneous:
Case Temp: Shows the actual temperature in °C inside the trans-
mitter.
Sample ID: Shows the assigned sample identification. This
identification is defined by the user to identify the location of the
sample
Temperature: Shows temperature in °C.
(Nt5K): Shows raw value of the temperature in 
Shows actual status of all in- and outputs.
Alarm Relay:
Relay 1 and 2:
Input:
Signal Output 1 and 2:
Only available if optional interface is installed. Review programmed
communication settings.
To simulate a value or a relay state, select the
 alarm relay,
 relay 1or 2
 signal output 1or 2
with the [ ] or [
Press the [Enter] key.
Change the value or state of the selected item with the [
[ ] key.
Press the [Enter] key.
 The value is simulated by the relay/signal output.
Active or inactive
Active or inactive
Open or closed.
Actual current in mA
] key.
] or
A-96.250.351 / 230320