Changing Parameters And Values - Swann AMU Rescon Operator's Manual

AMU Rescon
Operation
5.4.
Changing
parameters
Changing
values
30

Changing Parameters and values

The following example shows how to set the Q-Hflow sensor:
Sensors
Flow
Meas. Mode Resistivity
USP Operating Mode
Sensor parameters
Temp. Compensation
Sensors
Flow
Flow
None
Meas. Mode Resistivity
Q-flow
USP Operating Mode
Sensor parameters
Q-Hflow
Temp. Compensation
Sensors
Flow Q-Hflow
Meas. Mode Resistivity
USP Operating Mode
Sensor parameters
Temp. Compensation
Sensors
Flow Q-Hflow
Save ?
Meas. Mode Resistivity
Yes
USP Operating Mode
No
Sensor parameters
Temp. Compensation
Alarm
Alarm High 200M
Alarm Low
Hysteresis
Delay
Alarm
Alarm High 179 M
Alarm Low
Hysteresis
Delay
1 Select the parameter you want to
5.1.1
change.
None
2 Press [Enter]
off
3 Press [
5.1.1
highlight the required parameter.
None
4 Press [Enter] to confirm the selec-
tion or [Exit] to keep the previous
off
parameter).
 The selected parameter is
5.1.1
indicated (but not saved yet).
5 Press [Exit].
off
 Yes is highlighted.
5.1.1
6 Press [Enter] to save the new pa-
rameter.
 The system reboots, the new
off
parameter is set.
1 Select the value you want to
5.3.1.1.1
change.
2 Press [Enter].
0 M
1 M
3 Set required value with [
5 Sec
[
4 Press [Enter] to confirm the new
5.3.1.1.1
value.
5 Press [Exit].
0 M
 Yes is highlighted.
1 M
5 Sec
6 Press [Enter] to save the new val-
ue.
] or [ ] key to
] key.
A-96.250.351 / 230320
] or