Install Sensor Rcu - Swann AMU Rescon Operator's Manual

AMU Rescon
Installation
3.4.
Install Sensor
into Flow Cell
Install Sensor
into a tube
A-96.250.351 / 230320

Install Sensor RCU

The following instruction applies for all flow cells and pipe flanges.
To install the sensor RC U into a flow cell or a pipe flange proceed
as follows:
Installation in a by-pass is recommended. Choose the installation
point carefully to ensure the sensor is always filled with water, even
if sample flow is interrupted. To avoid the formation of air bubbles
inside the sensor, make sure that the air vent holes are always sub-
merged.
A Teflon tape
B
Sensor thread
C Flow cell
A
B
C
17