Toro Reelmaster 5610-D Operator's Manual page 23

4. Press the middle button to enter the PIN code
(Figure 29D).
Wait until the red indicator light of the InfoCenter
illuminates.
Note:
If the InfoCenter accepts the PIN code
and the protected menu is unlocked, the word
"PIN" displays in the upper right corner of the
screen.
Note:
Rotate the key switch to the O
then to the O position locks the protected menu.
N
You have the ability to view and change the settings in
the Protected Menu. Once you access the Protected
Menu, scroll down to Protect Settings option. Use the
right button to change the setting. Setting the Protect
Settings to O allows you to view and change the
FF
settings in the Protected Menu without entering the
PIN code. Setting the Protect Settings to O
protected options and requires you to enter the PIN
code to change the setting in the Protected Menu.
After you set the PIN code, rotate the key switch O
and back to the O position to enable and save this
N
feature.
Viewing and Changing the
Protected Menu Settings
1. In the Protected Menu, scroll down to Protect
Settings.
2. To view and change the settings without entering
a passcode, use the right button to change the
Protect Settings to O
3. To view and change the settings with a
passcode, use the left button to change the
Protect Settings to O
turn the key to the O
O position.
N
Setting the Auto Idle
1. In the Settings Menu, scroll down to Auto Idle.
2. Press the right button to change the auto idle
time between O
FF
Setting the Blade Count
1. In the Settings Menu, scroll down to Blade
Count.
2. Press the right button to change the blade count
between 5, 8, or 11 blade reels.
position and
FF
hides the
N
.
FF
, set the passcode, and
N
position and then to the
FF
, 8S, 10S, 15S, 20S, and 30S.
Setting the Mow Speed
1. In the Settings Menu, scroll down to Mow Speed.
2. Press the right button to select mow speed.
3. Use the center and right button to select the
appropriate mow speed set on the mechanical
mow-speed limiter on the traction pedal.
4. Press the left button to exit mow speed and save
the setting.
Setting the Height of Cut (HOC)
1. In the Settings Menu, scroll down to HOC.
2. Press the right button to select HOC.
3. Use the center and right button to select the
appropriate HOC setting. (If the exact setting is
not displayed, select the nearest HOC setting
from the list displayed).
4. Press the left button to exit HOC and save the
FF
setting.
Setting the Front and Rear Reel
Speeds
Although the front and rear reel speeds are calculated
by inputting the number of blades, mow speed and
HOC into the InfoCenter, the setting can be manually
changed to accommodate for different mowing
conditions.
1. To change the Reel Speed Settings, scroll down
to the F Reel RPM, R Reel RPM, or both.
2. Press the right button to change the reel speed
value. As you change the speed setting, the
display continues to show the calculated reel
speed based on blade count, mow speed and
HOC, which was previously entered, but the
new value is also displayed.
23