Toro Reelmaster 5610-D Operator's Manual page 17

Tilt-Steering Pedal
To tilt the steering wheel toward you, press the foot
pedal down, pull the steering tower toward you to
the most comfortable position, and release the pedal
(Figure 22).
Engine-Speed Switch
The engine-speed switch has 2 modes to change the
engine speed (Figure 23). By momentarily tapping the
switch, you can change the engine speed in 100 rpm
increments. If you hold the switch down, the engine
automatically moves to High or Low idle, depending
on which end of the switch you press.
Figure 23
1. Lower mow/raise control
lever
2. Key switch
3. InfoCenter
Enable/Disable Switch
Use the enable/disable switch in conjunction with the
lower mow/raise control lever to operate the cutting
units (Figure 23).
InfoCenter
The InfoCenter LCD display shows information about
your machine, such as the operating status, various
diagnostics, and other information about the machine
(Figure 23).
Key Switch
The key switch has 3 positions: O
S (Figure 23).
TART
g021208
4. Enable/disable switch
5. Engine-speed switch
6. Headlight switch
, O /R , and
FF N UN
Lower Mow/Raise Control Lever
This lever raises and lowers the cutting units and also
starts and stops the cutting units when the cutting
units are enabled in the M
cannot lower the cutting units when the mow/transport
lever is in the T
RANSPORT
Headlight Switch
Pivot the switch downward to turn on the headlights
(Figure 23).
Backlap Levers
Use the backlap levers in conjunction with the lower
mow/raise control lever for backlapping the reels
(Figure 24).
1. Backlap levers
17
mode (Figure 23). You
OW
position.
Figure 24
g021209