Toro Reelmaster 5610-D Operator's Manual page 12

1. Hose guides must lean toward the center cutting unit.
Note:
When installing or removing the
cutting units, make sure the hairpin cotter is
installed in the spring rod hole next to the
rod bracket. Otherwise, the hairpin cotter
must be installed in the hole in the end of
the rod.
6. Lower all lift arms completely.
7. Remove the lynch pin from the lift-arm pivot
yoke. Then, remove the cap
Figure 10
1. Lynch pin
8. For the front cutting units, slide a cutting unit
under the lift arm while inserting the carrier-frame
shaft up into the lift-arm-pivot yoke
(Figure 10).
g003975
2. Cap
(Figure 11).
Figure 9
1. Lift arm
2. Carrier-frame shaft
9. Use the following procedure on the rear cutting
units when the height of cut is above 19 mm
(3/4 inch).
A. Remove the lynch pin and washer securing
the lift-arm-pivot shaft to the lift arm and
slide the lift-arm-pivot shaft out of the lift
arm (Figure
12
Figure 11
3. Lift-arm-pivot yoke
12).
g019284
g003977