Toro Reelmaster 5610-D Operator's Manual page 11

A. Remove the 2 carriage bolts and nuts
securing the rod bracket to the cutting-unit
tabs (Figure 5).
Figure 5
1. Turf-compensation spring
2. Rod bracket
B. Remove the flange nut securing the
spring-tube bolt to the carrier-frame tab
(Figure 5) Remove the assembly.
C. Mount the spring-tube bolt to the opposite
tab on the carrier frame and secure with the
flange nut.
Note:
Position the bolt head to the outer
side of the tab as shown in
Figure 6
1. Opposite carrier-frame tab
D. Mount the rod bracket to the cutting-unit
tabs with the carriage bolts and nuts
6).
Important:
and cutting unit 5 (right front) , use the
rod-bracket mounting nuts to install
the hose guides to the front of the
cutting-unit tabs
The hose guides should lean toward the
center cutting unit
9).
3. Spring tube
Figure 6.
2. Rod bracket
On cutting unit 4 (left front)
(Figure 7 and Figure
(Figure 8 and
1. Cutting unit 1
g003949
2. Cutting unit 2
3. Cutting unit 3
4. Cutting unit 4
g003967
1. Hose guide (cutting unit 4
shown)
(Figure
2. Rod bracket
8).
Figure
11
Figure 7
5. Cutting unit 5
6. Reel motor
7. Weight
Figure 8
3. Nut
g030896
g015160