Toro Reelmaster 5610-D Operator's Manual page 13

Figure 12
1. Lynch pin and washer
B. Insert the lift-arm yoke onto the carrier-frame
shaft (Figure
C. Insert the lift-arm shaft into the lift arm and
secure it with the washer and lynch pin
(Figure 12).
10. Insert the cap over the carrier-frame shaft and
lift-arm yoke.
11. Secure the cap and the carrier-frame shaft to the
lift-arm yoke with the snapper pin
Note:
Use the slot if a steering cutting unit is
desired or use the hole if the cutting unit is to
be locked in position.
12. Secure the lift-arm chain to the chain bracket
with the snapper pin
Note:
Use the number of chain links described
in the cutting unit Operator's Manual.
Figure 13
1. Lift-arm chain
2. Chain bracket
13. On cutting unit 4 (left front) and cutting unit 5
(right front), insert the reel-motor hoses into the
respective hose guide.
14. Coat the spline shaft of the reel motor with clean
grease.
15. Oil the reel motor O-ring and install it onto the
motor flange.
16. Install the motor by rotating it clockwise so that
the motor flanges clear the bolts
11).
(Figure
(Figure 13).
3. Snapper pin
(Figure
Note:
the flanges encircle the bolts then tighten the
bolts.
Important:
hoses are not twisted, kinked or in the risk
of being pinched.
g003979
10).
1. Reel-drive motor
g003948
14).
13
Rotate the motor counterclockwise until
Make sure that the reel-motor
Figure 14
2. Mounting bolts
g004127