Using The Cutting-Unit Kickstand; Applying The Ce Decals - Toro Reelmaster 5610-D Operator's Manual

4. Outside the hood, insert the hook end of the
latch through the hole in the hood.
Note:
Make sure that the rubber sealing washer
remains to the outer side of the hood.
5. Inside the hood, insert the metal washer onto
the latch and secure with the nut.
Note:
Make sure that the latch engages the
frame catch when it is locked. Use the enclosed
hood latch key to operate the hood latch.
6
Using the Cutting-Unit
Kickstand
Parts needed for this procedure:
1 Cutting-unit kickstand
Procedure
Whenever you need to tip the cutting unit to expose
the bedknife/reel, prop up the rear of the cutting unit
with the kickstand to make sure that the nuts on the
back end of the bedbar-adjusting screws are not
resting on the work surface
1. Cutting-unit kickstand
Secure the kickstand to the chain bracket with the
snapper pin (Figure 19).
(Figure 18).
Figure 18
1. Chain bracket
2. Snapper pin
7

Applying the CE Decals

Parts needed for this procedure:
1 Warning decal
1 CE decal
1 Production year decal
Procedure
On machines requiring CE compliance, apply the
production year decal (Part No. 133-5615) near the
serial plate, the CE decal (Part No. 93-7252) near
the hood lock, and the CE warning decal (Part No.
133-2931) over the standard warning decal (Part No.
133-2930).
g003985
15
Figure 19
3. Cutting-unit kickstand
g004144