Lexmark B2338 User Manual page 43

Understanding the printer menus
Menu item
PCL SmartSwitch
Off
On*
PS SmartSwitch
Off
On*
Job Buffering
On
Off*
Mac Binary PS
Auto*
On
Off
Ethernet
Menu item
Network Speed
IPv4
Enable DHCP
On*
Off
IPv4
Set Static IP Address
IP Address
Netmask
Gateway
Enable IPv6
On*
Off
Enable DHCPv6
On
Off*
Stateless Address
Autoconfiguration
On*
Off
Note: An asterisk (*) next to a value indicates the factory default setting.
Description
Set the printer to switch automatically to PCL emulation when a print
job requires it, regardless of the default printer language.
Note: If PCL SmartSwitch is off, then the printer does not examine
incoming data and uses the default printer language specified in
the Setup menu.
Set the printer to switch automatically to PS emulation when a print
job requires it, regardless of the default printer language.
Note: If PS SmartSwitch is off, then the printer does not examine
incoming data and uses the default printer language specified in
the Setup menu.
Temporarily store print jobs in the printer hard disk before printing.
Note: This menu item appears only when a hard disk is installed.
Set the printer to process Macintosh binary PostScript print jobs.
Notes:
•
On processes raw binary PostScript print jobs.
•
Off filters print jobs using the standard protocol.
Description
Show the speed of an active network adapter.
Enable Dynamic Host Configuration Protocol (DHCP).
Note: DHCP is a standard protocol that allows a server to dynamically
distribute IP addressing and configuration information to clients.
Set the static IP address of your printer.
Configure IPv6 in the printer.
Run DHCPv6 in an IPv6 network.
Set the network adapter to accept the automatic IPv6 address configuration
entries provided by a router.
43