Tektronix WVR5200 Technical Reference page 26

Network Operation
IP Settings Configuration
16
To allow network access to the instrument, you need to set the IP address. Assign
Network addresses either automatically (DHCP) or manually. If your network
does not use DHCP, you need to manually enter the address for the instrument. To
obtain a valid IP address, contact your LAN administrator.
Perform the following steps to configure the IP settings on the instrument:
1. Press the CONFIG button to display the Configuration menu.
2. Use the General knob to navigate to Network Settings.
3. Press the right arrow key to select IP Config Mode.
4. Press the SEL button to select between DHCP and Manual.
5. If you selected DHCP, you are finished.
6. If you selected Manual mode, you need to set the Subnet Mask and Gateway
Address parameters. Contact your LAN administrator for these values. (Be
sure to use compatible addresses between the PC and the instrument.)
7. Press the down arrow key to select IP Address.
8. Press the right arrow key. A dialog box will appear that allows you to enter
the IP address.
9. Repeat steps 7 and 8 for the Subnet Mask and the Gateway Address.
10. If desired, select Instrument Name and then press the right arrow button to
assign the instrument a network name.
11. Press the CONFIG button to close the configuration menu.
WVR5200 System Integrator