Connections - D-Link Securicam Network DCS-2000 Manual

Connections

DC Power Connector
Ethernet Cable Connector
The DCS-2000 back panel features an RJ-45 connector for connections to
10Base-T Ethernet cabling or 100Base-TX Fast Ethernet cabling. This network
port supports the NWay protocol, allowing the Internet Camera to automatically
detect or negotiate the transmission speed of the network.
The Ethernet cable included with the DCS-2000 Internet
Camera is a Category 5 "straight through" cable. This is
the recommended cable type when the camera is
connected to a 100 Mbps Fast Ethernet network hub or
switch.
DC Power Connector
The DC power input connector is located on the DCS-2000 Internet Camera's
back panel and is labeled DC 12V with a single socket to supply power to the
Internet Camera.
Reset Button
Reset will be initiated when the reset button is pressed once and held until the
Power LED flashes through its cycle twice.
Factory reset will be initiated when the reset button is pressed continuously
for 5 seconds or when the Power LED changes from
cycles. (For example you will see the LED turn to
reset button when the LED turns red the second time). The Power LED will
begin to flash indicating that the Internet Camera's settings are reverting
back to the factory settings, then turn back to
press the reset button once, and the LED will flash to orange.
Reset Button
I/O Connector
green.
6
Ethernet Cable Connector
green to red
red twice, release the
To reset the camera,
for 2