D-Link Securicam Network DCS-2000 Manual page 31

Using & Configuring the DCS-2000 with a
NAT Router (continued)
Follow these steps to configure your router's Virtual Server settings:
Click Enabled.
Enter a different name for each entry.
Enter your camera's local IP Address (e.g., 192.168.0.146 in
the example in step
Select Both under Protocol Type (TCP and UDP).
If you are using the default camera port settings, enter 80 into
the Public and Private Port section, click Apply.
Scheduling should be set to Always so that the camera
images can be accessed at any time.
Repeat the above steps adding ports 5001, 5002, and 5003 to both the Public
and Private Port sections. A check mark appearing before the entry name will
indicate that the ports are enabled.
Important: Some ISPs block access to port 80. Be sure to check with your ISP
so that you can open the appropriate ports accordingly. Some ISPs block traffic
on commonly used ports to conserve bandwidth. If your ISP does not pass
traffic on port 80, you will need to change the port the camera uses from 80 to
something else, such as 800. Not all routers are the same, so refer to your
user manual for specific instructions on how to open ports.
Enter valid ports in the Virtual
Servers section of your router.
Please make sure to check
the box on this line to enable
settings.
on page 28) in the Private IP field.
31