Hardware Overview; Connections - D-Link DCS-950G User Manual

DCS-950G User's Manual

Hardware Overview

Connections

Reset Button
Reset will be initiated when the
reset button is pressed once and
Power LED begins to flash.
Factory Reset will be initiated when
the reset button is pressed
continuously for ten seconds.
Release the reset button and the
Power LED will begin to flash
indicating that the DCS-950G's
settings are reverting back to the
factory settings. The IP address will
also return to the default setting of
192.168.0.20.
DC Power Connector
The DC power input connector
is labeled DC 5V with a single
jack socket to supply power to
the DCS-950G.
D-Link Systems, Inc.
802.11g Antenna
The DCS-950G features
an 802.11g wireless
antenna for 802.11g
wireless connectivity to
your existing wireless
network. The DCS-950G
can
conjunction with an
802.11g
access point or router.
Ethernet Cable Connector
The DCS-950G features an RJ-45
connector for connections to 10Base-
T Ethernet cabling or 100Base-TX Fast
Ethernet cabling (which should be
Category 5 UTP cable). The port
supports the NWay protocol, allowing
the DCS-950G to automatically detect
or negotiate the transmission speed of
the network. The port also supports
MDI/X, which allows the use of either
straight through or cross-over cables.
Hardware Overview
be used in
compliant
8