D-Link Securicam Network DCS-2000 Manual page 81

Using IP surveillance Software (continued)
Monitor Program (continued)
Modulation Mode
You must select the input signal format (NTSC or PAL) for
displaying the original resolution of video stream from DCS-2000.
NOTE: You need to select the input signal format according to the camera
type or CCD module type that is connected to the DCS-2000.
Display Options:
In the video displaying frame of each channel, there are two status bars. The
upper bar contains "Camera location" and "time of the remote site." The lower
bar contains "Connection time" and "Recording time." All of them, shown in the
figure below, can be enabled or disabled here individually for the status indication.
Apply to full screen mode can also be turned on here. Once it has been checked,
the status bar in each channel showing date, location, connection, and recording
time will be shown in both display frame mode and full screen mode.
Location (channel number + Camera Name)
Connection Time (Day:Hour:Min)
Recording Time (Day:Hour:Min)
81
Remote Time
0 day 00:01