Hardware Overview; Connections - D-Link SECURICAM Network DCS-950 User Manual

DCS-950 User's Manual

Hardware Overview

Connections

Reset Button
Reset will be initiated when the reset
button is pressed once and Power LED
begins to flash.
Factory Reset will be initiated when the
reset button is pressed continuously
for ten seconds. Release the reset
button and the Power LED will begin
to flash indicating that the DCS-950's
settings are reverting back to the factory
settings. The IP address will also return
to the default setting of 192.168.0.20.
DC Power Connector
The DC power input connector is labeled
DC 5V with a single jack socket to supply
power to the DCS-950.
D-Link Systems, Inc.
Hardware Overview
Ethernet Cable Connector
The DCS-950 features an RJ-45
connector for connections to 10Base-
T Ethernet cabling or 100Base-TX
Fast Ethernet cabling (which should
be Category 5 UTP cable). The port
supports the NWay protocol, allowing
the DCS-950 to automatically detect
or negotiate the transmission speed
of the network.The port also supports
MDI/X, which allows the use of
either straight through or cross-over
cables.
8