Hardware Overview; Connections - D-Link SECURICAM Network DCS-950 User Manual

DCS-950 User's Manual

Hardware Overview

Connections

Reset Button
Reset will be initiated when the reset
button is pressed once and Power LED
begins to flash.
Factory Reset will be initiated when the
reset button is pressed continuously for
ten seconds. Release the reset button
and the Power LED will begin to flash
indicating that the DCS-950's settings
are reverting back to the factory settings.
The IP address will also return to the
default setting of 192.168.0.20.
DC Power Connector
The DC power input connector is labeled
DC 5V with a single jack socket to
supply power to the DCS-950.
D-Link Systems, Inc.
Hardware Overview
Ethernet Cable Connector
The DCS-950 features an RJ-45
connector for connections to
10Base-T Ethernet cabling or
100Base-TX Fast Ether net
cabling (which should be
Category 5 UTP cable). The port
supports the NWay protocol,
allowing the DCS-950
automatically detect or negotiate
the transmission speed of the
network. The port also supports
MDI/X, which allows the use of
either straight through or cross-
over cables.
to
8