Residual Risks - WAGNER VECTOR GRIP Owner's Manual

cream are necessary to protect the skin.
• Follow the coating material and solvent manufacturer's warnings and instructions.
• Extraction equipment should be installed by the user in accordance with local regulations.
• The objects being sprayed must be earthed.
• Before each use, check all hoses for cuts, leaks, abrasion or bulging of cover. Check
for damage or movement of couplings. Immediately replace the hose if any of these
conditions exist. Never repair a paint hose. Replace it with another grounded high-
pressure hose.
• Pulling the trigger causes a recoil force to the hand that is holding the spray gun.
The recoil force of the spray gun is particularly powerful when the tip has been removed
and a high pressure has been set on the airless high-pressure pump. Therefore, when
cleaning without tip set the pressure control valve to the lowest pressure.
• Use only manufacturer authorized parts. User assumes all risks and liabilities when using
parts that do not meet the minimum specifications and safety devices of the spray gun
manufacturer.
EXPLOSION PROTECTION IDENTIFICATION
X marking:
The spray gun corresponds with Ex II 2G IIC c T6 X and is, in accordance with Directive
2014/34/EU, suitable for use in explosion-hazardous areas—as of type Zone 1. Under
certain circumstances, the unit itself may cause the Zone 1 condition to be in effect.
Any static-electricity discharge from the spray gun is to be diverted to the grounded high-
pressure pump via the conductive high-pressure hose as stipulated.
The maximum surface temperature corresponds to the permissible material temperature.
This and the permissible ambient temperature can be found in the Technical Data.
To avoid the generation of machine sparks, prevent impact stresses and any work on the unit
with tools in the explosion-hazardous area.

Residual risks

Residual risks are risks, which cannot be excluded, even when equipment is used for the
intended purpose.
In such cases the applicable areas of the actual residual risks will be pointed out using warning
and/or prohibition signs.
Risk Source / Cause
Injection Atomized, high
injury pressure stream of
fluid
Explosion or Static electricity or
fire sparks
Hazardous Hazardous vapors
vapors from spray material
Vector Grip
Impact Preventative measures
Severe NEVER aim the gun at
injury or any part of the body
amputation
Severe Use well ventilated area
injury
Ground the spray gun
Severe Use well ventilated area
injury
Use mask
Can occur
during:
Setup,
Operation
Operation
Operation
11
GB