Figure 5-3 Lacp Configuration Instance - Zte ZXR10 5250 Series Configuration Manual

ZXR10 5250 Series Configuration Guide
Command
show lacp (all configuration modes)
show lacp aggregator (all configuration modes)
show lacp aggregator <1-15> (all configuration modes)
show lacp port (all configuration modes)
show lacp port [<portlist >] (all configuration modes)
zte(cfg)#
LACP Configuration Instance
l
Configuration Description
Switch A and switch B are connected through the aggregation port (binding the port
15 and port 16). Port 1 of switch A and port 2 of switch B belong to VLAN2. Port 3 of
switch A and port 4 of switch B belong to VLAN3. Members of the same VLAN can
communicate with each other. See

Figure 5-3 LACP Configuration Instance

l
Configuration Procedure
1. The detailed configuration of switch A is as follows:
zte(cfg)#set lacp enable
zte(cfg)#set lacp aggregator 3 add port 15-16
zte(cfg)#set lacp aggregator 3 mode dynamic
zte(cfg)#set lacp load-balance packet L2
SJ-20131111172707-002|2013-11-27 (R1.0)
clear trunk <trunklist>{ multicast-filter}
Figure 5-3.
5-18
ZTE Proprietary and Confidential
Function
Displays the LACP global
configuration information.
Displays brief information of all
LACP aggregation groups.
Displays detailed information of an
LACP aggregation group.
Displays aggregation status
information of all the LACP
member ports.
Displays aggregation status
information of LACP member
ports.
Clears the flag of the port multicast
filter.