Zte ZXR10 5250 Series Configuration Manual page 24

ZXR10 5250 Series Configuration Guide
l upgrading firmware
To return to global configuration mode from file system configuration mode, run the exit
command or press Ctr+Z.
NAS Configuration Mode
In global configuration mode, you can run the config nas command to enter NAS
configuration mode, which is shown as follows:
zte(cfg)#config nas
zte(cfg-nas)#
In NAS configuration mode, you can configure the access service of the switch, including
user access authentication and management.
To return to global configuration mode from NAS configuration mode, run the exit command
or press Ctr+Z.
Cluster Management Configuration Mode
In global configuration mode, you can run the config group command to enter cluster
management configuration mode, which is shown as follows:
zte(cfg)#config group
zte(cfg-group)#
In cluster management configuration mode, you can configure the cluster management
service of the switch.
To return to global configuration mode from cluster management configuration mode, run
the exit command or press Ctr+Z.
Basic Ingress ACL Configuration Mode
In global configuration mode, you can run the config ingress-acl basic number <1-99>
command to enter basic ingress ACL configuration mode, which is shown as follows:
zte(cfg)#config ingress-acl basic number 10
zte(ingress-basic-acl)#
In basic ingress ACL configuration mode, you can add, delete and move rules for a
specified basic ingress ACL.
To return to global configuration mode from basic ingress ACL configuration mode, run the
exit command or press Ctr+Z.
Extended Ingress ACL Configuration Mode
In global configuration mode, you can run the config ingress-acl extend number <100-199>
command to enter extended ingress ACL configuration mode, which is shown as follows:
zte(cfg)#config ingress-acl extend number 100
zte(ingress-extend-acl)#
3-8
SJ-20131111172707-002|2013-11-27 (R1.0) ZTE Proprietary and Confidential