Varian Turbo-V 2000 ICE Instruction Manual page 74

USE PROCEDURE
Controller Startup
To startup the controller plug the power cable into a
suitable power source and set the line switch to the
position 1.
Starting the pump
To start the pump press the START push-button on the
controller front panel.
Pump Shutdown
To shutdown the pump press the STOP push-button on
the controller front panel.
MAINTENANCE
The Turbo-V 2000 ICE series controller does not
require any maintenance. Any work performed on the
controller must be carried out by authorized personnel.
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com
1.
2.
3.
4.
5.
6.
7.
8.
9.
10. Flow meter connection cable socket.
11. Ground connection.
Controller 969-9448 and 969-9449 rear panel
67
INSTRUCTIONS FOR USE
Logic signals input/output connector that also checks the
power supplied to the pump and the excitation frequency
(the coupling connector is provided with the appropriate
loop-back plug).
Logic signals input/output connector in compliance with
the SEMI specifications.
Power out socket (120 Vac, 1 A) for power supply to the
optional devices (vent device, primary pump activation
relay, etc).
Pump cable socket.
Power supply line input connector.
Heater jacket power cord socket.
Provision for RS-232 - RS-422 - RS-485 communication
port connector (provided as an option).
Line switch with magnetothermal protection.
Heater jacket power supply fuse.
When a fault has occurred it is possible to use the
Varian repair service. Replacement controllers are
available on an advance exchange basis through
Varian.
!
Before carrying out any work on the controller,
disconnect it from the supply.
If a pump is to be scrapped, it must be disposed off in
accordance with the specific national standards.
ERROR MESSAGES
For a certain type of failure, the controller will self-
diagnose the error and the messages described in the
following table are displayed.
WARNING!
87-900-929-01 (H)