Measure Set. Options - Epson SF-510 User Manual

Measure set. options

Setting
Activity Type
Mode
AT Lap
AT Pause
Target Pace
1
Waypoint
2
HR
Alarm
Settings
Options
Run*
Walk
Bike
Chronograph*
Interval
Goal
SETTING 01 to 05
OFF*
ON
OFF*
SETTING 01 to 03
OFF*
ON
OFF*
ON*
OFF
Tones
Vib. (vibration)
Tones & Vib. (vibration)*
OFF
Description
Use this setting when running or jogging.
Use this setting when walking or exercising at a reduced pace.
Use this setting when performing any exercise that does not
require you to swing your arms, such as riding a bike.
Chronograph mode allows you to measure split times and lap
times simultaneously.
See "Measuring time, distance, and speed" on page 30.
Interval mode allows you to switch between periods of heavy
(sprint) or light (recovery) exercise over set times or distances.
See "Using the interval function" on page 33.
Goal mode automatically measures your activity until a set time
or distance is reached.
See "Using the goal function" on page 39.
Records laps automatically when a set time or distance is
reached.
Set the lap time or distance.
You can set five times or distances within the following range:
Time: 01'00" to 60'00" (in increments of 1 minute)
O
Distance: 0.1 to 10.0 mi (0.1 to 10.0 km) in increments of 0.1
O
mi (0.1 km)
See "Recording laps automatically" on page 43.
Automatically stops measuring when you stop running, and
resumes when you continue running.
See "Starting/stopping measurement automatically" on page 44.
Set the target time and pace range for one mile or kilometer. An
alarm sounds if you are outside the set pace range.
You can set three target paces within the following range.
Target Pace: 1'00" to 15'00"/mi or km (in increments of 1
O
second)
Pace Range: 00'05" to 03'00"/mi or km (in increments of 1
O
second)
See "Setting a pace" on page 45.
By specifying the registered waypoint, you can display the
direction to the point, the distance, and the difference in
elevation. As you approach the specified point, an alarm sounds.
You can measure pulse (heart rate) with the built-in sensor.
See "Measuring time, distance, and speed" on page 30.
Set the alarm type and time (1 to 10 minutes).
You can also set this from Sys. Settings.
81