Advertisement
OPENING THE
SENSOR
PREPARATION
FOR MOUNTING
THE SENSOR
WIRING AND
MOUNTING THE
SENSOR
OTHER
MOUNTING
OPTIONS
From behind, before installation
• Paste the template.
• Drill as instructed.
Position the sensor and tighten the two screws. Leave wires long
enough to reach the terminal block.
For the mounting on the
upper part of the door
operator profile, use the EBA
support.
From the front, after installation
• Insert screws, but do not screw them
fully home.
• Run the cable through the hole.
For a mounting into the ceiling, use the ECA embedding
support.
• Cut one of the cable openings for the
wire.
12-24V
COM
AC/DC
This device may be fixed on the ceiling, as long as the
spherical part of the sensor is facing in the direction
opposite the door, and as long as an angular position of
around 70° is chosen for the antenna.
For a better water tightness,
use the ERA protection cap.
NO
NC
2/8
Advertisement
