Adjustment After Roller And Clutch Replacement; Adjusting The Leading Edge Registration Of Image Printing - Kyocera KM-2550 Service Manual

2FT-3.0

(10) Adjustment after roller and clutch replacement

Perform the following adjustment after refitting rollers and clutches.

(10-1) Adjusting the leading edge registration of image printing

Make the following adjustment if there is a regular error between the leading edges of the copy image and original.
U066
U034
(P. 1-6-35)
Caution:
Check the copy image after the adjustment. If the image is still incorrect, perform the above adjustments in maintenance
mode.
Procedure
Enter maintenance mode.
Enter "034" using the numeric keys.
Press the start key.
Select the "ADJ. RCL ON TIMING"
using the up/down cursor keys.
Press the start key.
Select the items to be adjusted
using the up/down cursor keys.
Press the interrupt key.
Press the start key
to output a test pattern.
Is the leading edge
registration correct?
Press the stop/clear key to exit
maintenance mode.
1-6-16
U071
(P. 1-4-17)
Start
RCL ON: Drawer
RCL BYP: Bypass tray
RCL T1: First paper feeder
RCL T2: Optional second paper feeder
RCL T3: Optional third paper feeder
RCL DUP: Duplex copying (second face)
No
Yes
End
Correct image
Press the start key
The new setting is stored
For output example 1, decrease
the value using the left cursor
key.
For output example 2, increase
the value using the right cursor
key.
Setting range (Initial setting)
RCL ON: –5.0 – +10.0 (4.0)
RCL BYP: –5.0 – +10.0 (3.6)
RCL T1: –5.0 – +10.0 (3.6)
RCL T2: –5.0 – +10.0 (3.6)
RCL T3: –5.0 – +10.0 (3.6)
RCL DUP: –5.0 – +10.0 (4.5)
Changing the value by 1 moves the
leading edge by 0.1 mm.
Leading edge registration
Output Output
example 1 example 2
Figure 1-6-31