Adjusting The Center Line Of Image Printing - Kyocera KM-2550 Service Manual

2FT

(10-3) Adjusting the center line of image printing

Make the following adjustment if there is a regular error between the center lines of the copy image and original when
paper is fed from the drawer.
U067
U034
(P. 1-6-36)
Caution:
Check the copy image after the adjustment. If the image is still incorrect, perform the above adjustments in maintenance
mode.
Procedure
Enter maintenance mode.
Enter "034" using the numeric keys.
Press the start key.
Select the "ADJ. LSU OUT TIMING"
using the up/down cursor keys.
Press the start key.
Select the items to be adjusted
using the up/down cursor keys.
Press the interrupt key.
Press the start key
to output a test pattern.
Is the image correct?
Press the stop/clear key to exit
maintenance mode.
1-6-18
U072
(P. 1-4-18)
Start
LSU OUT: Drawer
LSU BYP: Bypass tray
LSU T1: Ffirst paper feeder
LSU T2: Optional second paper feeder
LSU T3: Optional third paper feeder
LSU DUP: Duplex copying (second face)
No
Yes
End
Correct image
Press the start key.
The new setting is stored.
For output example 1, decrease
the value using the left cursor key.
For output example 2, increase
the value using the right cursor key.
Setting range (Initial setting)
LSU OUT: –7.0 – +10.0 (–1.0)
LSU BYP: –7.0 – +10.0 (0.4)
LSU T1: –7.0 – +10.0 (–1.2)
LSU T1: –7.0 – +10.0 (–1.2)
LSU T1: –7.0 – +10.0 (–1.2)
LSU DUP: –7.0 – +10.0 (0.3)
Changing the value by 1 moves the
center line by 0.1 mm.
Center line of printing
Output Output
example 1 example 2
Figure 1-6-33