Ventilation; Heating - Telair Iceberg 12000 Installation And User Manual

1
2
1
3
The minimum cooling value is marked by the small-
est dot, the maximum cooling value is marked by
the largest [Fig. 15 ref. 2].
The thermostat controls the temperature automati-
cally, but the speed of the fan must be set manu-
ally by the user.
Set the fan speed required on the relevant selector
switch [Fig. 15 ref. 1].
To use the air conditioner in the most effective
manner, we suggest the following settings:
Minimum speed - Minimum cool (night-time)
Medium speed - Medium cool
Maximum speed - Maximum cool
To use the conditioner more efficiently, we suggest
you perform the following operations:
- 12 -
GB
4
3
2
4
15
First choose Maximum Cool and the third ventila-
tion speed.
When you have reached the temperature you
want, choose the first ventilation speed, then turn
the thermostat knob counter-clockwise until the
compressor goes off (you can tell this has happened
when the noise diminishes).
Now select the second ventilation speed again,
and the system will preserve the temperature you
have set.

5.6 Ventilation

If you want to move the air inside the vehicle with-
out heating or cooling, proceed as follows:
Press the Cold Air /Hot Air selector [Fig. 15 ref.
3] in the position
Position the Thermostat [Fig. 15 ref. 2] selector
in the position
Press the ON/OFF switch [Fig. 15 ref. 4] to po-
sition it
Choose the ventilation speed required [Fig. 15
ref. 1].

5.7 Heating

The electrical heater of the air conditioner cannot
replace a conventional heating system, but it does
help to warm up the air in the morning or on cool
days.
Press the Cold Air /Hot Air selector in the position
Position the Thermostat [Fig. 15 ref. 2] selector in
the position
Press the ON/OFF switch [Fig. 15 ref. 4] to position
Choose the ventilation speed required [Fig. 15 ref.
1].