CrimeStopper CS-2015.FM.RevB Installation Instructions Manual page 6

STARTER DISABLE:
CONNECT TO
ORANGE WIRE
OF ALARM
PRE-WIRED
STARTER DISABLE
RELAY & SOCKET
START OUTPUT
FROM ALARM
6-PIN HARNESS
Orange/Black: (-) OEM Disarm Output
This wire provides a Ground pulse to disarm vehicles' Factory anti-theft system prior to a Remote Start. Connect
this wire to the vehicles' anti-theft disarm wire. This wire is sometimes found coming off the Driver's door key switch
or at the Factory Anti-theft control module.
\
PIN 1: BROWN:
PIN 2: GRAY:
PIN 3: RED:
PIN 4: RED:
PIN 5: PINK:
PIN 6: PINK/WHITE: IGNITION or ACCESSORY #2 OUTPUT (30 Max.)
WIRING: 9-PIN Connector
IGN. SWITCHED
STARTER WIRE
YELLOW
BROWN
WIRING: 6-PIN High Current Connector
STARTER OUTPUT (30A Max.)
ACCESSORY (HEAT/AC) (30A)
+12V POWER INPUT (BATTERY) FUSED (30A)
+12V POWER INPUT (BATTERY) FUSED (30A)
IGNITION 1 (30A Max.)
CUT
BLUE
ORANGE
ORANGE
IGNITION SWITCHED
"ON" & HOT THROUGH
CRANKING
STARTER
MAKE CERTAIN TO
CONNECT BROWN
WIRE TO STARTER
MOTOR SIDE!!!
NOTE!: Use External Relays
for High Current Ignition
and/or Accessory circuits
greater than 30A. Failure to
do so could result in damage
to the unit that is not covered
under warranty.