CrimeStopper CS-2015.FM.RevB Installation Instructions Manual page 15

TACH (RPM) REFERENCE MODE & TACH FINDER FEATURE
TACH FINDER FEATURE:
This system now includes a Tach Finder mode to assist in locating a valid or viable tach source for your installation.
Follow the Tach Finder steps to locate and /or verify a tach signal. When following the steps, the unit will begin to
flash the parking lights if you have the White/Red wire connected to a valid tach source. If lights do not flash, then
try another wire until you locate a tach signal that will cause the Parking lights to flash. NOTE: On some vehicles
equipped with daytime running lights, it may be difficult to see any flashing parking lights. In this case your only
notification will be the slight "ticking" sound coming out of the module from the on-board flashing light relay.
TACH FINDER:
1. Open hood (or Ground the Blue Hood Pin wire if no hood pin is installed)
2. Start Engine with the key.
3. Press the Program button for 2 seconds
4. Lights will begin flashing if the White/Red wire is connected to a valid tach
5. Once Tach is located then turn off engine and close hood to abort.
6. See Tach Reference programming below.
TACH PROGRAMMING:
1. Open hood (Or Ground Blue wire if no hood pin installed.)
2. Connect WHITE/RED wire to a valid Tach source.
3. Start engine with key.
4. Press program button 5 times, then wait for 5 light flashes.
5. Wait at least one second then push program button again (1) time, you should get a light flash with the button
press. This unit is now at option #1-Tach Learning.
6. Press the #2 Unlock Button on remote transmitter. The unit will read and program the Tach source. The lights
will flash twice for confirmation.
7. If lights do not flash twice for confirmation, then try another tach source or try the tach finder.
NOTE (1): The Tach Signal locations suggested on the bottom of page13 are provided as a guide, your
vehicle may differ. Some locations will NOT be a good location for Tach source due to RF noise or
Computer Data. The CS-2011RS/2015FM may not detect a clean signal. If you are unable to locate a Tach
Source, use the "Smart Tachless" or "Timed Crank" mode.
NOTE (2) The CS2011RS/2015FM will operate in "Smart Tachless" Mode [by default] unless a Tach
Reference has been programmed. Once a Tach source is programmed, the unit will automatically operate
in Tach Mode.