CrimeStopper CS-2015.FM.RevB Installation Instructions Manual page 5

MOBILE ACCESSORY PROTECTION:
GREEN/RED
M.A.P. OUTPUT
OFF
ACC
IGN
START
Blue/Black: (-) Remote Aux. Output 2 (Optional, may require relay)
This wire provides a Momentary (-) Negative output when Button #3 (Trunk) is pressed and held for more than 2
seconds. Output stays on as long a remote button is held down. Connect to the Negative activation circuit of an
auxiliary module or device. If the circuit requires +12V, then a relay is required. RELAY WIRING: Connect the
Blue/Black wire to terminal 85, connect relay terminals 86 and 87 to +12V constant power. Connect terminal 30 of
the relay to the +12V positive device/circuit to be activated.
Blue/White: (-) Passenger Door Unlock Output (Optional, requires relay)
This wire activates when the unlock button on the remote is pressed a second time upon disarming. This wire is
used for the Optional Separate Driver's/Passenger Unlock feature. Connects to unlock circuit for passenger door or
doors. See DOOR LOCK WIRING for special configuration options.
Orange: (-) Negative Starter Disable/Negative Ignition/Anti-Grind Output
This wire should be connected to the Yellow wire of the pre-wired relay socket for the starter disable. Connect the
blue wire of the relay socket to the Ignition switched wire on the vehicle. Cut the vehicle starter wire and connect
each half to an Orange wire on the relay socket. This output also turns on with remote start and functions as a
"Negative when Running" wire. See diagram on next page.
WIRING: 9-PIN Connector
+
85 86
IGN.
87
SWITCHED
87A 30
C U T
MOBILE ACCESSORY PROTECTION
Connect relay as shown to interrupt the power
wire of mobile accessories such as Audio system
or Cellular telephone. The Alarm will disconnect
these accessories when in VALET PARK MODE.
F M
105. 5
RADIO