Connecting The Module To The Motherboard; S/Pdif Connector - DFI HD310-Q87 User Manual

Connecting the Module to the Motherboard

Note:
The system board used in the following illustrations may not resemble the actual one.
These illustrations are for reference only.
The extension module requires two cables, including the LPC cable and the power cable, to
connect to the motherboard for additional COM/Parallel ports via the LPC connector. The illus-
tration of connecting the extension module to the motherboard is shown below.
the LPC connector on the motherboard.
USB
Power
Cable
EXT-6C1PR
the extension module connected to the motherboard via the LPC connector.
Chapter 2 Hardware Installation
Chapter 2
LPC
LPC
LPC
Cable

S/PDIF Connector

SPDIF out
Key Ground
S/PDIF
SPDIF in
+5V
1 5
The S/PDIF connector is used to connect an external S/PDIF port. Your S/PDIF port may be
mounted on a card-edge bracket. Install the card-edge bracket to an available slot at the rear
of the system chassis then connect the audio cable to the S/PDIF connector. Make sure pin 1
of the audio cable is aligned with pin 1 of the S/PDIF connector.
30
www.dfi .com