Disposal Information - Flex GE MH 18.0-EC Original Operating Instructions

GE MH 18.0-EC
 Regularly blow out the housing interior
and motor with dry compressed air.
 Regularly clean the filter cover.
Remove filter cover and blow it out with
dry compressed air.
Replacing Velcro or backing pad
(Figure P-U)
 Take hold of the sanding plate together
with the sanding head to prevent
the sanding plate from turning.
 Turn the bolts in anti-clockwise direction
and remove.
 The Velcro plates can be detached/
removed.
 Replace parts.
 Assemble sanding head in reverse
sequence.
Replacing the brush ring (Figure V)
 Remove the sanding head (see section
"Replacing Velcro or backing pad (Figure
P-U)").
 Loosen the retaining screws.
 Take the ring out of the housing.
 Insert a new brush ring into the housing
and screw in the retaining screws.
 Assemble sanding head in reverse
sequence.
Replacing the protective corners
(Figure W-X)
 Remove protective corners
to be replaced.
 Attach new protective corners.
In the corners reduce the contact pressure,
otherwise there will be excessive load on
the tips of the triangular sanding disc.
Heavily worn corners of the triangular
sanding head can easily be replaced.
Repairs
Repairs may be carried out by an authorised
customer service centre only.
NOTE
During the warranty period do not loosen
the screws on the housing.
Non-compliance will deem the guarantee
obligations of the manufacturer null and
void.
Spare parts and accessories
Other accessories, in particular insertion
tools, can be found in the manufacturer's
catalogues.
Exploded drawings and spare-part lists
can be found on our homepage:
www.flex-tools.com

Disposal information

WARNING!
Render redundant power tools unusable:
mains operated power tool by removing
–
the power cord,
battery operated power tool by removing
–
the battery.
EU countries only
Do not throw electric power tools
into the household waste!
In accordance with the European Directive
2012/19/EU on Waste Electrical and
Electronic Equipment and transposition into
national law used electric power tools must
be collected separately and recycled in an
environmentally friendly manner.
Raw material recovery instead of
waste disposal.
Device, accessories and packaging should be
recycled in an environmentally friendly
manner. Plastic parts are identified for
recycling according to material type.
WARNING!
Do not throw batteries into the household
waste, fire or water. Do not open used
batteries.
EU countries only:
In accordance with Directive 2006/66/EC
defective or used batteries must be recycled
NOTE
Please ask your dealer about disposal
options!
23