Declaration Of Conformity; Exemption From Liability; Disposal Information - Flex XFE 7-15 Original Operating Instructions

Gears
NOTE
Do not loosen the screws on the gear head during the
warranty period.
Non-compliance will deem the guarantee obligations of the
manufacturer null and void.
Replacement of wear parts
Change Velcro pad
Pull out the mains plug.

Remove the polishing tool.

Place machine on its back.

Figure H:
Release and remove screws with Torx wrench (1.).

Remove worn Velcro pad (2.).

Remove contaminants from interior.

Figure I:
Align securing holes and fit new Velcro pad (3.).

Figure J:
Insert screws and tighten with Torx wrench (4.).

(Tightening torque 2.5-3.0 Nm (1.8-2.2 ft. lb.))
Carry out test run. Check for imbalances and vibrations.

CAUTION!
An incorrect torque setting can damage the tool and the
surfaces being worked on.
Repairs
Repairs may be carried out by an authorised customer service
centre only.
Spare parts and accessories
NOTE
Only the tools released by FLEX may be used.
For other accessories, in particular tools and polishing aids,
see the manufacturer's catalogues.
Exploded drawings and sparepart lists can be found on our
homepage: www.flex-tools.com

Disposal information

WARNING!
Render redundant power tools unusable by removing the
power cord.
EU countries only
Do not throw electric power tools into the household
waste!
In accordance with the European Directive 2012/
19/EU on Waste Electrical and Electronic Equipment and
transposition into national law used electric power tools must
be collected separately and recycled in an environmentally
friendly manner.
NOTE
Please ask your dealer about disposal options!
14

-Declaration of Conformity

We declare under our sole responsibility that the product
described under page 5 conforms to the following standards or
normative documents:
EN 62841 in accordance with the regulations of the directives
2014/30/EU, 2006/42/EC, and 2011/65/EU.
Responsible for technical documents:
FLEX-Elektrowerkzeuge GmbH, R & D
Bahnhofstrasse 15, D-71711 Steinheim/Murr
Eckhard Rühle
Manager Research &
Development (R & D)
03.05.2019
FLEX-Elektrowerkzeuge GmbH
Bahnhofstrasse 15, D-71711 Steinheim/Murr

Exemption from liability

The manufacturer and his representative are not liable for any
damage and lost profit due to interruption in business caused
by the product or by an unusable product.
The manufacturer and his representative are not liable for any
damage which was caused by improper use of the power tool
or by use of the power tool with products from other
manufacturers.
XFE 7-15 / XCE 10-8
Klaus Peter Weinper
Head of Quality
Department (QD)