Disposal Information; Declaration Of Conformity; Exemption From Liability - Flex Giraffe GDE 10 Manual

Replacing the sanding housing (Figure P)
Remove sanding head from device.

Remove tool.

Loosen screws.

Remove sanding housing.

Install new sanding housing and secure using the screws.

Repairs
Repairs may be carried out by an authorised customer service
centre only.
NOTE
During the warranty period do not loosen the screws on the
housing. Non-compliance will deem the guarantee obligations
of the manufacturer null and void.
Spare parts and accessories
Other accessories, in particular insertion tools, can be found in
the manufacturer's catalogues.
Exploded drawings and spare-part lists can be found on our
www.flex-tools.com
homepage:

Disposal information

WARNING!
Render redundant power tools unusable:
–
mains operated power tool by removing the power cord,
–
battery operated power tool by removing the battery.
EU countries only
Do not throw electric power tools into the household
waste!
In accordance with the European Directive 2012/19/EU
on Waste Electrical and Electronic Equipment and
transposition into national law used electric power tools
must be collected separately and recycled in an envi-
ronmentally friendly manner.
Raw material recovery instead of waste disposal.
Device, accessories and packaging should be recycled in
an environmentally friendly manner. Plastic parts are iden-
tified for recycling according to material type.
NOTE
Please ask your dealer about disposal options!
16

-Declaration of Conformity

We declare under our sole responsibility that the product des-
cribed on page 6 conforms to the following standards or norma-
tive documents:
EN 60745 in accordance with the regulations of the
directives 2014/30/EU, 2006/42/EC, and 2011/65/EU.
Responsible for technical documents:
FLEX-Elektrowerkzeuge GmbH, R & D
Bahnhofstrasse 15, D-71711 Steinheim/Murr
Peter Lameli
Technical Head
15.12.2020
FLEX-Elektrowerkzeuge GmbH
Bahnhofstrasse 15, D-71711 Steinheim/Murr

Exemption from liability

The manufacturer and his representative are not liable for any
damage and lost profit due to interruption in business caused
by the product or by an unusable product.
The manufacturer and his representative are not liable for any
damage which was caused by improper use of the power tool
or by use of the power tool with products from other manufactu-
rers.
GDE 10
Klaus Peter Weinper
Head of Quality
Department (QD)