Siemens Simotics Connect 400 Operating Instructions Manual page 52

Commissioning
6.2 Commissioning with Android
Result
The further onboarding process is performed automatically. This process takes approximately
one minute. Successful completion of the onboarding process is confirmed.
After commissioning is completed, you are automatically logged off from the device and the
Bluetooth connection is disconnected.
The connectivity module starts data recording and transfer of the data in the preset intervals.
After the first measurements, connection with the "SIDRIVE IQ Fleet" is established automatically
for the first time so that you can see the current connection status immediately.
The connectivity module automatically starts the calibration procedure on the motor. It requires
10 measuring cycles with the motor in the RUN state and 10 measuring cycles with the motor
in the OFF state. Precise data is displayed in "SIDRIVE IQ Fleet" as an "operating mode" signal only
after the calibration process:
• Value "0": Motor off (OFF), sensor calibrated
• Value "1": Motor status not defined, sensor not calibrated
• Value "3": Motor on (RUN), sensor calibrated
No additional measures are required to support calibration.
50
SIMOTICS CONNECT 400
Operating Instructions, 08/2021, A5E50161952B AE