Siemens Simotics Connect 400 Operating Instructions Manual page 27

"Device overview" page
When the "SIDRIVE IQ Config" application starts, by default, you see a list of all of the currently
visible assets on the "Device overview" page. You can also display all of the assets visible in the
history. A list entry contains the information about an asset. The following diagram explains the
pictograms in a list entry.
①
②
③
④
⑤
⑥
⑦
⑧
SIMOTICS CONNECT 400
Operating Instructions, 08/2021, A5E50161952B AE
To identify an asset, press the motor icon (LED of the connectivity module flashes)
You see all of the currently visible assets under this tab.
BLE name and MAC address of the currently selected connectivity module
Under this tab, you see all of the assets visible in the past.
Connection status of the connectivity module to the MindSphere application SIDRIVE IQ Fleet
(onboarding status)
• "Green" status: Connected
• "Orange" status: No Onboarding yet
• "Red" status: Error during upload
Bluetooth interface signal strength display
WLAN configuration status of the connectivity module:
• "Green" status: WLAN configured and operating correctly
• "Red" status: WLAN not configured or has a fault
Status of the connectivity module battery:
• "Green" status: sufficient charge
• "Red" status: low charge, 30% or less
Note: Replace the battery in good time. If disturbances occur in data transmission, replace the
batteries (Page 104).
Commissioning
6.2 Commissioning with Android
25