Gate Delay During Closing; Lock Time; Backlash Time; Pre-Flashing Time - V2 PD9 Manual

GATE DELAY DURING CLOSING

In order to avoid the colliding of gate's during the closing the
time of delay should de introduced r.Ch, which is adjustable
from 0 to 2 minutes. In such a case the closing time of
gate1 is delayed in comparison to the gate2.

LOCK TIME

Before the opening phase starts, the gearcase has to energi-
ze the electrical lock in order to release it and enable the
gate movement. The time t.SEr determines the duration of
excitation, and is adjustable from 0 to 3 seconds. In case
there is no motor lock, set up on no.

BACKLASH TIME

To avoid that the gate starts the opening phase before the
electrical locks is unhooked, it is possible to introduce a time
of inversion adjustable from 0 to 3 seconds. In this way
during the opening phase, the gate inverts the motion through
the set time permitting the unhooking of the electrical lock.

PRE-FLASHING TIME

This menu permits the introduction of a pre-flashing that
occurs before any movement of the gate either in opening or
in closing phase: the time of pre-flashing can be adjusted
from 0 to 2 minutes.
MOTOR 1 POWER
Such a menu enables the sensitivity adjusting of the motor 1
current sensor from 1 to 10.
MOTOR 2 POWER
Such a menu enables the sensitivity adjusting of the motor 1
current sensor from 2 to 10.

START SLOWING DOWN

Such a menu enables the motor slowing down start as for
the opening and closing phase.

END OF STROKE SLOWING DOWN

Such a menu allows enabling the door slowing down at their
end of stroke by means of two speeds which can be set up
according to your needs.
vEL1 corresponds to 25% of power.
vEL2 corresponds to 50% of power.
21