Technical Specifications - Maxitrol GV60 Installation And Operating Instructions Manual

Remote electronic ignition and control system
Table of Contents

Advertisement

Available languages

Available languages

INSTALLATION INSTRUCTIONS

TECHNICAL SPECIFICATIONS

Gas combination control according to CSA or CE ap-
SURYDO VHH ODEHO IRU FHUWL¿FDWLRQ
FUELS
CSA: Suitable for natural, manufactured, mixed gases,
OLTXH¿HG SHWUROHXP JDVHV DQG /3 JDVDLU PL[WXUHV
CE:
Suitable for use with gases of EN 437 gas family 1,
2 and 3.
APPROVALS
CSA: ANSI Z21.78/CSA 6.20 for U.S. & Canada,
ANSI Z21.20/CSA 6.20 for U.S. & Canada
CE:
Gas Appliances Directive
298-2003, DIN EN 126
Infrared Handset: GADAC Guidance Sheet B12
PRESSURE DROP/CAPACITY
CSA: 1" W.C. at 65,000 BTU/hr
CE:
2.5 mbar at 1.2 m³/h air
RANGE OF REGULATION
CSA: 10,000 to 85,000 BTU/hr
CE:
Class C according EN 88
REGULATOR ADJUSTMENT
CSA: 3" W.C. to 5" W.C. (7.5 to 12.5 mbar); 8" W.C. to 12"
W.C. (20 to 30 mbar)
CE:
5 to 40 mbar
CE+CSA: 3" W.C. to 12" W.C. (7.5 to 30 mbar)
Convertible Regulator: 3 to 4.5" NG/8.5 to 11.5" LP
MOUNTING POSITION
Mount valve 0° to 90°, in any direction (including vertically)
from the upright position of the gas control knob.
MAXIMUM INLET PRESSURE
CSA: ½ psi (34.5 mbar)
CE:
50 mbar (20" W.C.)
MAIN GAS CONNECTION
&6$
LQ 137 5S
,62  LQWHUQDO WKUHDG IRU  PP
10 mm, 8 mm, 6 mm outside diameter tube.
&(
5S
,62  LQWHUQDO WKUHDG IRU  PP  PP
8 mm, 6 mm outside diameter tube.
INLET AND OUTLET CONNECTION
Side or Bottom
MAXIMUM ALLOWED TORQUE INLET AND OUTLET
CSA: 280 inch-pounds
CE:
35 Nm
PILOT GAS CONNECTION
&6$  816 IRU ó´ RU
CE:
M10x1 for 4 mm or 6 mm tubing
THERMOCOUPLE/INTERRUPTER BLOCK
11/32-32 UNS, M10x1, M9x1, M8x1
AMBIENT TEMPERATURE RANGE
Combination control: 32 °F to 176 °F (0 °C to 80 °C)
Latching solenoid valve: 32 °F to 176 °F (0 °C to 80 °C)
Receiver RF without batteries: 176 °F (80 °C)
Receiver RF with batteries:
2009/142/EG
and EN
´ WXELQJ
16
131 °F (55°C)
Receiver infrared with/without batteries:
Handset: 140 °F (60 °C)
Wall switch/Touchpad: 176 °F (80 °C)
Switch panel: 221 °F (105 °C)
Module: 176 °F (80 °C)
Ignition cable: 302 °F (150 °C)
Misc. cables: 221 °F (105 °C)
Infrared sensor: 176 °F (80 °C)
Cable with relay: 158 °F (70 °C)
HANDSETS
NOTICE
The handsets, receivers, wall switches, switch panels
and touchpads are not interchangeable with previous
electronics.
RADIO FREQUENCY
CSA: 315 MHz for U.S. and for Canada.
For FCC ID:
a) User Information acc. to FCC15.21:
PRGL¿FDWLRQV QRW H[SUHVVO\ DSSURYHG E\ WKH SDUW\
responsible for compliance could void the user's
DXWKRULW\ WR RSHUDWH WKH HTXLSPHQW
For Canada - IC:
Statement acc. RSS Gen Issue 3, Sect. 7.1.3
This device complies with Part 15 of the FCC Rules
and with Industry Canada license-exempt RSS
standard(s). Operation is subject to the following two
conditions: (1) this device may not cause harmful in-
terference, and (2) this device must accept any in-
terference received, including interference that may
cause undesired operation.
CE:
433.92 MHz for Europe
BATTERIES – HANDSET
1 x 9 V,
new design 2012: 3 x 1,5 V „AAA"
(alkaline recommended)
BATTERIES – RECEIVER
4 x 1.5 V "AA" (alkaline recommended)
An AC Mains Adapter may be used instead of batteries.
NOTICE
Only the Mertik Maxitrol AC Mains Adapter or one pre-
approved by Mertik Maxitrol can be used. Use of other
adaptors can render the system inoperable.
V MODULE
CSA: Inlet: 115 VAC/60 Hz; 210 VA
Outlet: 115 VAC/60 Hz; 100 VA
Built-in fuse: 2.5 A
CE:
Inlet: 230 VAC/50 Hz; 210 VA
Outlet: 230 VAC/50 Hz; 100 VA
Built-in fuse 2,5 A
LOCATION
Locate the combination gas valve where it is not exposed
to steam cleaning, high humidity, dripping water, corrosive
chemicals, dust or grease accumulation, or excessive heat.
To assure proper operation, follow these guidelines:
/RFDWH FRPELQDWLRQ JDV YDOYH LQ D ZHOOYHQWLODWHG DUHD
5 / 84
FOR OEM USE ONLY
131 °F
(55°C)
Changes or

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents